smith and wesson model 10-5 38 special serial numbers

If it starts with 'D' and has only numbers after the 'D,' the gun is from 1968-1977. (If the serial starts with 'C', but is C402923 or less, the gun actually isn't a model 10, but earlier.) If it starts with a 'C' and has only numbers following the C, then it is pre 1968. Since we are assuming it is a model 10, that is where I'll start the serial ranges. Before 1957, it wouldn't say '10, or Model 10' or anything like that anywhere on it. If it is really marked as a model 10, and isn't a. (SW added dashes after the main model number to designate model variations) Example '10-3 or 10-5' This is the model number. Also, if you open the cylinder, it will reveal a piece of metal on the left (probably where you got the 4 digit number) Under, or above that, there might be a number along with your 10. (never two, and if it has zero letters, then it actually pre-dates the model 10) A model 10 WILL ALWAYS have either one or three letters in it. The serial of a model 10 will have AT LEAST one letter in it, and will almost certainly be 7 characters total. If it is a newer gun, the serial might be elsewhere on the gun as well. If it has grips that cover that section of the frame, you may have to remove them. The actual serial number will be on the butt - the very bottom of the gun's grip. The assembly numbers helped the people at the factory keep track of what parts went to what gun. 38 Military & Police Model of 1905 4th Change - 758,296 manufactured c.The 4 digit number you've posted is an assembly number. 38 Military & Police Model of 1905 3rd change - 94,803 manufactured c. 38 Military & Police Model of 1905 1st and 2nd change - 73,648 manufactured c. 38 Military & Police Model of 1905 - 10,800 manufactured c. Additionally, at approximately serial number 316648, the factory began heat treating cylinders. Variations įour minor design changes were made during the production run of the Model 1905, with two, the 1st and 2nd changes, overlapping in manufacture. This model had a 'five screw' frame, with four screws holding the side plate and one screw at the front of the trigger guard. At various times throughout its production, it was offered with a round or square butt grip frame checkered walnut or hard rubber grip stocks with or without a lanyard ring on the butt blue, nickel, or chrome (produced in very small quantities) finish and a barrel length of 2', 4', 5', 6', or 6.5'. 38 Hand Ejector models, is a six-shot revolver built on the Smith and Wesson K frame, with a swing-out cylinder chambered in. 38 Military & Police Victory Model and the S&W Model 10.

38 Smith & Wesson Model Military & Police Model of 1905 is the third of Smith & Wesson's. Revolver Smith & Wesson Military & Police Model of 1905

Smith and wesson model 10-5 38 special serial numbers